e+a USA warehouse.photo bottom fade

Customer Centric Support + Free Download Center

e+a provides technical support throughout the prototype phase to OEMs integrating rotors and stators into systems.
intro photo welcome page

The design of the complete system is the customer's responsibility, but e+a provides advice and support in the following areas to aid in a smooth integration:

  • Indirect measurement of rotor temperature
  • Calculation of interference fits
  • Test a prototype on an e+a test bed (add'l cost)
  • Mechanical installation of shafts into PM rotors
  • Guidelines for machining motor elements
  • Aligning a PM rotor inside a stator
  • Typical water jacket designs
  • Machining rotors and stators
  • Thermal issues

e+a does not build to stock so all orders have a delivery time associated with manufacturing the rotors and stators. Delivery times can vary from 8-16 weeks or longer depending on the type and complexity of the product, the availability of materials and whether engineering or tooling is required.

Technical information at your fingertips enabling informed decisions.

Select a download of interest or contact support today!

Design and test of an advanced system for energy generation.

Click immediately below for a technical paper below that describes the development of a high-performance gas turbine engine power generator using e+a permanent magnet generator elements, Bellkim Energy foil bearings and a multi-level inverter designed by Oztek Corp.

Our Partners
  • Oztek logo
  • Bellkim logo